Depending on your tolerances, you may need to use a soft mallet to tap the pieces into place. To attach each end piece, match the three inverted dots with the corresponding dots on the main body, and pop them into place. To start assembling your kaleidoscope, you’ll need the main extruded triangle body piece and the end pieces. Clear lenses: 2x 3″ (76.2mm) diameter circles, no thicker than 1/8″ (3.2mm).Rectangular mirrors: 3x 160mm x 55mm, no thicker than 1/16″ (1.6mm).You can use a laser cutter for this, but you can also use thinner material and cut the pieces by hand. You’ll also need to cut the mirror pieces and clear acrylic lenses. In transparent filament, print out ten LED covers, or adjust the number to match the number of LEDs you are using. You’ll need one large triangular body, two eyepieces, one eyepiece cover, one LED container, and one coil holder. Debra recommends using iridescent two-color filament, which is what is shown here. 3D Print the Partsįirst, you’ll need to 3D print all of the STL files from the Geek Mom Projects design documentation. Check out this project on their project site, maker.io. You can get all the supplies you need to make your own kaleidoscope from this project’s sponsor, Digi-Key. Clear acrylic, either precut 3″ discs or up to 1/8″ thick sheet if laser cutting.Mirror sheet, either 1/16″ acrylic (for laser cutting or scoring+snapping) or thinner mirror sheet you can cut with scissors.3D printer filament in transparent (for LED diffusers) and opaque color(s) of your choice.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |